| 164The turbo scoop! Since the car's bonnet was crushed I scrapped the bonnet but kept the scoop. I found anearly mint blue bonnet on craigslist for $35, and when all is finished I intend to fit the scoop to it where I can duct the airflow over the controller heatsink. | | 1645Waving goodbye to the turbo 1.0l 3 cylinder. Thanks to Carneys Waste for the use of the truck and hoist. | | 1646After removing the engine and cutting away most of the damage. Also after test fitting new crumple zones and part of the driver side headlamp suround from a donor car. | | 1647Gearbox mount dropped 3/4 inches to clear battery box. The red adapter plate will mount the electric motor to the existing gearbox. | | 1648Gearbox mount dropped 3/4 inches to clear battery box. | |
| 1649Gearbox mount dropped 3/4 inches to clear battery box. | | 1650After welding in new crumple zones and top crossmember from donor car. And after 5 coats of paint. Note the towing bar and TurbineTech strut tower tie bar. | | 1651 | | 1652 | | 1653After welding in new crumple zone and top crossmember from donor car. And, after 5 coats of paint. | |